View HRF-ROC093XC-T_1251049.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

HRF-ROC093XC
Advance Information
Radio On A Chip 860-928 MHz Frequency Agile With SPI Bus Interface
Features
High Integration Minimizes System Cost Data Rates from 4 to 128.8 Kbits/Sec Direct Connection To Microprocessor Integrated Antenna Switch Adjustable detection bandwidths, data rates Adjustable gain, detection level/ hysterisis Low and high beta FSK detection modes Integrated Manchester coding/decoding 6 Prog. Power Levels, Freq. And Tx/Rx/Standby Modes Operates From Single 2.5V Power Supply Surface Mount Leadless Plastic Packaging
Description
The Honeywell HRF-ROC093XC is a half-duplex transceiver for use in wireless communication and data applications. Direct microprocessor connection for control and data transfer, eliminate the need for additional ICs, while integrated data encode/decode reduces the instruction set requirements on the microprocessor. The HRF-ROC093XC is ideally suited for use in battery powered wireless applications in conjunction with microprocessors for voice and data communication. Adjustable data rates, filter bandwidths and detection levels allow the IC to be used in a wide variety of high sensitivity / high EMI environments.
Product Photo
Functional Schematic
T/R SW Low Pass Filter LNA PA Limiter/ RSSI Demod
Poly Phase CP PLL XTAL Digital (SPI Interface, Encoder/Decoder, FIFO, Correlator)
HRF-ROC093XC Wireless Transceiver
Web Site: Email: 2003 09325XC
www.mysoiservices.com mysoiservices@honeywell.com Published June 2003 Page 1
Honeywell Solid State Electronics Center 12001 State Highway 55 Plymouth, Minnesota 55441-4799 1-800-323-8295
HRF-ROC093XC
Advance Information
RF Electrical Specifications @ + 25oC
Parameter
Rx Sensitivity 1db Compression Tx Output Power Tx Power Control Data Rate, Tx / Rx Channel Rejection Max Detection BW Control/Data I/O
Test Condition
Vdd = 2.5V Vdd = 2.5V
Frequency
860- 928 MHz 860- 928 MHz 860- 928 MHz
Minimum
Typical
-95 +5 +3 18 128 50 250 10
Maximum
Units
dBm dBm dBm dB Kbps dB KHz MHz
Continuous Data Adjacent Channels Fc + 1MHz IQ Baseband FilterPassband Serial Peripheral Interface (SPI). Direct Connection To Microcontroller/Microprocessor
DC Electrical Specifications @ + 25oC
Parameter
VDD Power Supply Voltage Power Supply Current During Tx, Output Power Dependant (915 MHz) Power Supply Current (IDD) During Rx (915MHz) Sleep Mode Current Consumption CMOS Logic Level (0) CMOS Logic Level (1)
Minimum
2.4 16
Typical
2.5 26 35 <1
Maximum
2.6
Units
V mA mA uA V V
0 1.7
0.7 VDD
Absolute Maximum Ratings1
Parameter Absolute Maximum Units
Maximum Input Power VDD + 2.8 V ESD Voltage (Human Body Model) 200 V Operating Temperature - 40 to + 85 Degrees C Storage Temperature - 40 to + 150 Degrees C (Note 1) Operation Of The HRF-ROC093XC Beyond Any Of These Parameters May Cause Permanent Damage. ESD Protection: The HRF-ROC093XC Contains reduced ESD Protection Circuitry for sensitive RF I/O. Precautions Should Be Taken During Handling/Assembly Until Protected By External Circuitry or Housings
Web Site: Email: 2003 09325XC
www.mysoiservices.com mysoiservices@honeywell.com Published June 2003 Page 2
Honeywell Solid State Electronics Center 12001 State Highway 55 Plymouth, Minnesota 55441-4799 1-800-323-8295
HRF-ROC093XC
Typical Application
VDD
Advance Information
Analog Power
HRF ROC093XC
Digital Power SPI
48 Package Outline 1
37 36
7mm x 7mm 48 pin Leadless Plastic Chip Carrier
12
TOP VIEW Need 48 pin package dwg.
HRF-ROC093XC
25 13 24
Low inductance RF/DC ground connection required below part as bottom ground pad is used for all device grounding. Additionally, this connection prodvides a direct connection to the die for enhanced thermal dissipation. Package shown not to scale.
Web Site: Email: 2003 09325XC
www.mysoiservices.com mysoiservices@honeywell.com Published June 2003 Page 3
Honeywell Solid State Electronics Center 12001 State Highway 55 Plymouth, Minnesota 55441-4799 1-800-323-8295
HRF-ROC093XC
Pin Configuration
HRF-ROC093XC 48 Pin LPCCTM (7 mm X 7 mm) Package Pin List * RF/Digital ground is provided through backside slug pad. Advance Information
Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Name SWITCH TX PA AC OUT VP PA PA DC OUT VCO TANK2 VCO TANK1 VP VCO VMOD LG VMOD SM TX MOD DATA VP PLL REXT PLL PD OUT CRYSTAL 1 CRYSTAL 2 RTEST OUT PTEST OUT SQUELCH 1 SQUELCH 2 VP DIG RX OUT TX DATA V SPI INT OUT SPI DATA OUT
Function Optional connection - PA AC OUT to SWITCH ANTENNA AC-coupled PA output - 10 pf series cap Positive supply for PA PA Direct Connection for output bias VCO external tank connection VCO external tank connection Positive supply for VCO VCO varactor input, high deviation VCO varactor input, low deviation Data charge pump output Positive supply for PLL PLL bais resistor Phase Detector charge pump output Reference crystal Reference crystal PLL R-counter out PLL N-counter output Bit 1, 4-level window Select Bit 1, 4-level window Select Positive supply for DIG Demodulated Rx data Logic level Tx data SPI Interrupt output SPI Serial Data output
Pin 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
Name SPI CLK IN SPI SSN IN DIG DATA IN SPI DATA IN RESET N MIXER REF SCHM TRIG LEV PRE TRIG DATA V CM REF VP BB Q FILT BW N Q FILT BW P I FILT BW N I FILT BW P Q MIX ADJ I MIX ADJ VP MIX VP LNA RF GAIN VP LNA LNA INPUT LNA BIAS ADJ SWITCH RX SW ANTENNA
Function SPI Clock SPI Slave Select Digital Section Rx Text Input, Ext. digital data SPI Serial Data input Digital Section Reset Mixer Ref Voltage Filter Detection level monitor/filtering RX Analog Data, predetection Common mode voltage filtering Positive supply for Baseband Filter BB Filter BW Control BB Filter BW Control BB Filter BW Control BB Filter BW Control Dynamic Range Adjust Dynamic Range Adjust Positive supply for Mixer Positive supply for LNA LNA Gain Control: open - low, ground - high Positive supply for LNA LNA input DC Bias Resistor Optional connection - LNA INPUT to SWITCH ANTENNA Switch connection to Antenna
Web Site: Email: 2003 09325XC
www.mysoiservices.com mysoiservices@honeywell.com Published June 2003 Page 4
Honeywell Solid State Electronics Center 12001 State Highway 55 Plymouth, Minnesota 55441-4799 1-800-323-8295
HRF-ROC093XC
Customer Demonstration Board
Advance Information
The Customer Demonstration Board provides the ROC093XC radio with a PIC microcontroller that interfaces to a PC through a USB connection. Using the software provided and a PC, the user can send files and perform range tests. For a more complete understanding of the operation of the radio, the user can also control the operating frequency, power levels and all internal registers for early product development/prototyping. The board operates from a USB power source, three "AA" batteries or an external power supply. Single antenna operation is attained through the internal RF switch. Separate Tx/Rx/ ports are also available. A kit is available, HRF-ROC093XC-K, which includes two boards, antennas, USB cable, documentation and control software.
Ordering Information
Ordering Number
HRF-ROC093XC -T HRF-ROC093XC -K
Note 2: Contact Honeywell for details
Delivered On Tape And Reel2 Engineering Evaluation Kit
Product
Honeywell reserves the right to make changes to improve reliability, function or design. Honeywell does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent rights nor the rights of others.
Web Site: Email: 2003 09325XC
www.mysoiservices.com mysoiservices@honeywell.com Published June 2003 Page 5
Honeywell Solid State Electronics Center 12001 State Highway 55 Plymouth, Minnesota 55441-4799 1-800-323-8295

▲Up To Search▲

Price & Availability of HRF-ROC093XC-T

	To Download HRF-ROC093XC-T Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .